I-81 North – New York

Project Description The New York Department of Transportation (NYDOT) used FORTA-FI to reinforce I-81, both north and south lanes, between mile markers 74.2 and 81.7. This mill and fill project included 40,000 lb of FORTA-FI in the wearing course. The high tensile strength fiber reinforcement replaced the use of polymers. The FORTA Voyager fiber feeder […]

Read More

Street Rehab – Irvine, CA

Project Description The residential area off Culver and Bryan Street in Irvine, CA reinforced their city streets with FORTA-FI during an annual street rehabilitation. Over 34,900 tons of fiber reinforced asphalt concrete (FRAC) were used in a 2” overlay over dozens of residential streets. Typical distresses were found throughout the neighborhood like traverse and block […]

Read More

Residential Rehabilitation – Fullerton, CA

Project Description The neighborhood southwest of the intersection of Orangethorpe Avenue and Euclid Street in Fullerton, CA used both FORTA-FI and Surface-EXT in a residential rehabilitation that included both asphalt and slurry. This project included a 2” mill and fill of one street, several dig-out locations that were patched, and slurry sealing of the neighborhood. […]

Read More

1/27 E53 from Javorná to Železná Ruda – Czech Republic

Project Description Road I/27, which serves as the boundary of the Sumava National Park, is located in a mountainous and heavily wooded area that experiences harsh and frequent weather changes. Due to the heavy snowfall, it is subject to freeze-thaw issues as well as plow damage to the wearing course. In an effort to reduce […]

Read More

Sporilovska Street – Prague, Czech Republic

Project Description Sporilovska street, a major connection of the D1 motorway, connects one of the most densely populated areas of Prague to regional capitals throughout Europe. Being that it is the shortest route from the capital to northern Germany, its daily load is upwards of 100,000 vehicles—10,000 of those being heavy trucks. All four lanes […]

Read More

Evropska Street Phase 1 – Prague, Czech Republic

Project Description Serving as a connection to Vaclav Havel International Airport, as well as a main entrance point to the capital, this four-lane divided highway accrues a daily traffic load of 40,700 small vehicles and nearly 2,000 trucks and buses. In an effort to mitigate cracking and rutting, approximately 2,000 tons of FORTA-FI reinforced asphalt […]

Read More

Valencia Road – Tucson, AZ

Project Description FORTA-FI was used to reinforce the asphalt at the intersection of Valencia and Kolb Road in Tucson, AZ. The total project was approximately 76,000 tons and used 30,800 lb of fiber. The asphalt thickness varied from 4.5” to 6.5” in depth in two different lifts, and the total length of the project was […]

Read More

Cape Canaveral Air Force Facility – Brevard County, FL

Project Description The roadway into the Air Force facility at Cape Canaveral in Brevard County Florida was repaired and reinforced with FORTA-FI asphalt fiber. The road that was repaired is Highway 401, and the job consisted of side road entries, passing lanes, and exit lanes. This project was 3 miles long, used 13,000 lb of […]

Read More

Multi-National Distribution Center – Arcadia, FL

Project Description An American multi-national distribution center in Arcadia, FL used FORTA-FI fiber to reinforce a new parking lot. This new construction used 1,600 lb of fiber and was laid at a thickness of 6”. FORTA-FI was used in both the wearing course and base layer of this project. The wearing course was 2” thick, […]

Read More

Porter Drive – Trumbull County, OH

Project Description Trumbull County chose to pave Porter Drive, a low volume road, in Trumbull, OH using fiber reinforced 100% RAP fines. The county was looking to utilize their fines, which is usually a waste material, from extracting their chipping aggregate and using it for a leveling course. By using Pave-Aid, a polyamide FORTA fiber […]

Read More